1911Forum - View Single Post - Springfield Armory 1911 in 9mm
View Single Post
  #53  
Old 03-19-2020, 09:33 PM
USMCSarge USMCSarge is offline
Junior Member
 
Join Date: Mar 2018
Location: Californicate
Posts: 2
Well, I know this post was a while ago, but...
My problem turned out to be my Wilson Combat 10-round magazines!!!
They are just a CH too tall, and when I slammed them into the SA Loaded 9mm, They smacked the bottom of the ejector, pushing it up out of the frame, and then wedged the ejector between the slide and frame.
Sent it to Springfield and they (as they SHOULD have done initially) drilled and roll pinned it properly. Not a problem since. Even using the very same mags that "caused" the problem!!!
Shame on SA for saving $5.00 and gluing the ejector into the frame.
All the best to everyone.
Semper Fi.
Reply With Quote