1911Forum - View Single Post - Barrel Overhang Modification Photo
View Single Post
  #9  
Old 01-30-2012, 03:56 PM
pistolwrench's Avatar
pistolwrench pistolwrench is offline
Senior Member
 
Join Date: Jul 2000
Location: Prescott Valley, AZ
Posts: 6,923
I think I can be of some help.

This first picture shows the 'barrel bed length'. It is measured from the
vertical impact surface to the top of the feed ramp. You need to slightly angle your calipers to get beneath the top edge break of the VIS.
This measurement needs to be .246" minimum. This one measures right at .246".



This shows a new and un-fit Kart bbl fully nested in the frame. Notice the overhang.


The next two show a Kart bbl faced back and re-throated to privide the proper gap.





Pic of the unsupported case area. If needed it could be deepened even further.



I hope this helps!
__________________
Chuck
Cheap-Fast-Good...pick any two!

Last edited by pistolwrench; 04-07-2012 at 03:45 PM.
Reply With Quote