1911Forum
Forum   Reviews   Rules   Legal   Site Supporters & Donations   Advertise


Go Back   1911Forum > Search Forums


Showing results 1 to 25 of 575
Search took 0.03 seconds.
Search: Posts Made By: SOA1911
Forum: General Gun Discussion 08-22-2015, 08:05 PM
Replies: 107
Views: 2,033
Posted By SOA1911
Better athlete than me.

Better athlete than me.
Forum: Reloading Bench 08-22-2015, 08:01 PM
Replies: 14
Views: 442
Posted By SOA1911
Charles, I have to agree with what Trigger Creep...

Charles, I have to agree with what Trigger Creep said in post #4. I have found this to be so true--even more so while shooting rifles.
Forum: General Gun Discussion 08-22-2015, 07:48 PM
Replies: 107
Views: 2,033
Posted By SOA1911
I agree with both dsk and LW McVay. I really...

I agree with both dsk and LW McVay. I really enjoy all kinds of guns, and I own and shoot a lot of different Makes, Types, and Models. I prefer the pattern 1911 over and above any, but I may shoot a...
Forum: Colt 08-22-2015, 09:30 AM
Replies: 64
Views: 4,822
Posted By SOA1911
A LGS in Middle Tennessee that I frequently shop...

A LGS in Middle Tennessee that I frequently shop is getting all kinds of Colts from Davidson's Gallery of Guns. Yesterday, they had two (2) of the wonderful Special Combat Government models in .45...
Forum: Rock Island Armory 08-17-2015, 09:02 AM
Replies: 27
Views: 787
Posted By SOA1911
Will do. I just sent their Customer Service...

Will do. I just sent their Customer Service Department an email.
Forum: Rock Island Armory 08-17-2015, 07:48 AM
Replies: 27
Views: 787
Posted By SOA1911
Bamashooter, I am in no hurry, so I believe that...

Bamashooter, I am in no hurry, so I believe that your suggestion would be wise. Thanks guys.
Forum: Rock Island Armory 08-16-2015, 07:38 PM
Replies: 27
Views: 787
Posted By SOA1911
Bret, most handgun cartridges headspace off the...

Bret, most handgun cartridges headspace off the case mouth. It's a fact. But, you are correct: in this case, reliability is my problem.
Forum: Rock Island Armory 08-16-2015, 07:15 PM
Replies: 27
Views: 787
Posted By SOA1911
Nothing wrong with a Colt--I have plenty--except...

Nothing wrong with a Colt--I have plenty--except Deltas do not headspace on the case mouth.
Forum: Rock Island Armory 08-16-2015, 06:47 PM
Replies: 27
Views: 787
Posted By SOA1911
As it has been mentioned, any way I go, I can not...

As it has been mentioned, any way I go, I can not loose. It would probably be prudent to contact Armscor again and give their gunsmiths another chance. I can not say enough about their customer...
Forum: Rock Island Armory 08-16-2015, 09:07 AM
Replies: 27
Views: 787
Posted By SOA1911
What would you do?

I have a RIA Tactical G10 10mm, and while it is a very nice gun, it is the only 1911 that I have that is unreliable. I broke-in the gun with factory ammo (180 grain FMJ from both Armscor and Sig...
Forum: Ammo Can 08-15-2015, 09:18 AM
Replies: 13
Views: 429
Posted By SOA1911
I regularly shoot 38 Super Auto (both reloads and...

I regularly shoot 38 Super Auto (both reloads and factory ammo), and of those three choices I like Aguila the best. It is very reliable, accurate, and burns clean. The Fiocchi ammo is excellent too....
Forum: General Gun Discussion 08-02-2015, 05:43 PM
Replies: 52
Views: 1,797
Posted By SOA1911
I have a wide assortment of the brands that you...

I have a wide assortment of the brands that you have mentioned, as well as, many other brands. I think that it is a matter of personal preference. Each company builds top notch 1911s with extremely...
Forum: Reloading Bench 08-02-2015, 05:22 PM
Replies: 7
Views: 510
Posted By SOA1911
For the big H&K MK23, which likes to run a stout...

For the big H&K MK23, which likes to run a stout load, I like 9.20 grains of AA5 under a 185 gr HRN XTP, and for my 1911s, about 8.80 grains of AA5 under a 185 gr Nosler JHP Custom Competition bullet...
Forum: Reloading Bench 08-02-2015, 08:27 AM
Replies: 7
Views: 510
Posted By SOA1911
Trigger Creep, I appreciate the tip on your AA5...

Trigger Creep, I appreciate the tip on your AA5 load. I too shoot the 230 gr Xtreme bullet, but have not had quite as much success as you with my 230 gr loads using AA5 relative to WST, Titegroup,...
Forum: Wilson Combat 07-29-2015, 01:16 PM
Replies: 14
Views: 612
Posted By SOA1911
My X-tac is one of my very favorite 1911s. I...

My X-tac is one of my very favorite 1911s. I would trust my life with it.
Forum: Gunsmithing & Troubleshooting 07-26-2015, 09:03 AM
Replies: 5
Views: 366
Posted By SOA1911
My suggestion would be to contact RIA and explain...

My suggestion would be to contact RIA and explain your problem as you have in this post. I had to send my 10mm back a couple weeks ago, and I found that their customer service personnel was as good...
Forum: Gunsmithing & Troubleshooting 07-26-2015, 08:54 AM
Replies: 14
Views: 521
Posted By SOA1911
I have the exact gun, and like brzusa.1911...

I have the exact gun, and like brzusa.1911 suggested, I place a piece of black electrical tape over the area where the spent cases are leaving brass marks. It works great!
Forum: Rock Island Armory 07-18-2015, 09:30 AM
Replies: 4
Views: 329
Posted By SOA1911
I had somewhat similar problems with my new...

I had somewhat similar problems with my new FS-Tactical G10 10mm, and I just sent it back to RIA. I was extremely satisfied with their customer service. After doing a search on the RIA sub-forum, it...
Forum: Rock Island Armory 07-16-2015, 07:14 AM
Replies: 0
Views: 266
Posted By SOA1911
RIA Customer Service - It's Great!

Recently, I purchased a RIA FS-Tactical G10 Model 51914 in 10mm, and while I like the gun a lot, I was experiencing lots of FTF and Failures to Lock-back the slide on the last round. (This was after...
Forum: Colt 06-13-2015, 07:46 PM
Replies: 17
Views: 1,180
Posted By SOA1911
Congrats! I picked mine up today after noticing...

Congrats! I picked mine up today after noticing that this particular O1992 had the best build quality of this model that I had ever seen. The slide-to-frame fit was great: no movement what so ever!...
Forum: Reloading Bench 05-23-2015, 09:24 AM
Replies: 14
Views: 884
Posted By SOA1911
I have been using 7.4 of CFE under a 200 gr RNFP...

I have been using 7.4 of CFE under a 200 gr RNFP from The Blue Bullet Company, and this load is an absolute tack-driver in my S&W Model 22-4 .45 ACP. With this load, both my revolvers and 1911's seem...
Forum: General Gun Discussion 05-23-2015, 08:55 AM
Replies: 44
Views: 1,588
Posted By SOA1911
I love all the vets that have made such great...

I love all the vets that have made such great sacrifices for our country. Many young men and women never came home. I just watched Chosin, and it just amazes me how special these guys were. There are...
Forum: General Gun Discussion 01-11-2015, 08:57 AM
Replies: 64
Views: 3,866
Posted By SOA1911
CavCop...+1. I have one of Mr. Lauck's...

CavCop...+1. I have one of Mr. Lauck's Professional Models, and it is incredible!
Forum: General Gun Discussion 01-09-2015, 07:28 PM
Replies: 74
Views: 4,372
Posted By SOA1911
Godspeed. Thank you so much for the bio on Kruzr.

Godspeed. Thank you so much for the bio on Kruzr.
Forum: General Gun Discussion 12-24-2014, 09:20 AM
Replies: 27
Views: 1,632
Posted By SOA1911
I am always amazed when I watch these craftsmen...

I am always amazed when I watch these craftsmen at work and using aged-old techniques to create or reproduce masterpieces. I just wish that I had the means to purchase one of these wonderful works of...
Showing results 1 to 25 of 575

 
Forum Jump

All times are GMT -5. The time now is 09:14 AM.


NOTICE TO USERS OF THIS SITE: By continuing to use this site, you certify that you have read and agree to abide by the Legal Terms of Use. All information, data, text or other materials ("Content") posted to this site by any users are the sole responsibility of those users. 1911Forum does not guarantee the accuracy, integrity, or quality of such Content.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Copyright 2015 1911Forum.com, LLC. All Rights Reserved