Welcome To 1911Forum
General
Hardware & Accessories
Applications
Marketplace
Firearms and receivers are not allowed to be bought, sold, or traded on this forum.
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Other Firearms & Tools
1911 Manufacturers
Forum Support
Latest Posts
-
I find it befuddling to some of the responses I received in my "cold spray welding post" as too its non conformance to firearms. Then to be censored by a moderator with no vision in mechanical wonders or how things work? I guess silver solder use in firearms repairs is the only solution? Top...1 reply 0 views
-
Another newbie question... On my RIA MS45 that I'm working on, the back of the extractor hole is really tight. Tap it in with a hammer tight. The extractor goes in fine until the fat part at the pack end of the extractor hits the back of the slide. I also have to thread a long punch through the...0 replies 0 views
-
Major news outlets are in full spin mode after shootings in Jacksonville Florida. How tragic that well behaved and Law-abiding College students are exposed to the evil of guns while enjoying time on the beach. What totally mystifies politicians and Brandon is the fact the vast majority of...24 replies 576 views
-
Good afternoon ladies and gents! Just joined up and figured I’d give a shout out to all the members! East Tennessean here, by way of Charlotte NC. New to the 1911 side of things, as I’ve always been a striker fired polymer kind of guy and still have and shoot quite a few. Recently acquired, by...26 replies 325 views
-