1911Forum banner

Lead me to the right thumb safety please.

1K views 9 replies 10 participants last post by  july19 
#1 ·
I have an ambi on my carry gun and don't like it being exposed and bumping the seat belt. I want to go with a strong side safety and have these preferences:
1) extended length
2) low profile (rides tight to frame and isn't really thick)
3) textured - prefer serrated but checkered would be ok too
4) stainless steel

What's the ticks for my Springfield carry gun?
 
#4 ·
I just did a gun with the same requirements and used the Wilson BulletProof part. Fit was fine, but it did have a couple of sharp edges that had to be reworked. Had it been a blued part (thus trashing the bluing in re-working) I would have been annoyed.

Overall I think it meets your needs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top