Welcome To 1911Forum
General
Hardware & Accessories
Applications
Marketplace
Firearms and receivers are not allowed to be bought, sold, or traded on this forum.
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Other Firearms & Tools
1911 Manufacturers
Forum Support
Latest Posts
-
Another newbie question... On my RIA MS45 that I'm working on, the back of the extractor hole is really tight. Tap it in with a hammer tight. The extractor goes in fine until the fat part at the pack end of the extractor hits the back of the slide. I also have to thread a long punch through the...5 replies 105 views
-
I have some 5.56 and M80 that I want to reload. New to rifle reloading I already reload 45ACP. I went out and purchased the RCBS Military Crimp Removal Swagging tool. My question is will this tool take out the whole crimp or should I get the RCBS Primer Pocket Uniformer? Will the swagging from...47 replies 1K views
-
Curious to see who would like a an all steel Garrison CCO. It would be nice to have one in the 700-800 dollar range.11 replies 490 views
-
Not a huge problem here, but my question is how often do you experience a flipped primer when you’re reloading ? I-have a Dillon XL650 that I’ve used a lot, I would guesstimate that i’ve loaded probably 30k + rounds through it and have had trouble with flipped primers, Sometimes very...75 replies 2K views
-
I opened a new thread since the first was discussion about planning and direction. So here we are, I'll open with a basic parts list. -Frame: JEM .45 ramped govt, 25lpi checkered front strap -msh: EGW arched checkered -Slide/barrel: 10mm Fusion 6" "Freedom" series, no front serrations, only...44 replies 1K views